1-665
ï›™ Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
03.04 1 Alarms
1.3 List of action numbers
The following list describes the actions stated in the alarm texts under "Action %.."
according to their numbers.
No. 1
Explanation Run Init phase (tasks are initialized after power on).
Not allowed if -
Remedy -
No. 2
Explanation Perform reset (VDI signal: Reset, mode group reset or after power on).
Not allowed if -
Remedy -
No. 3
Explanation Activate Reset Init blocks (VDI signal: Reset).
Not allowed if -
Remedy -
No. 4
Explanation Perform reset, end of program has been detected (NC block with M30).
Not allowed if -
Remedy -
No. 5
Explanation Change the mode to the MDA or AUTOMATIC program operating mode
(VDI signal: Mode group).
Not allowed if 1. The channel is active (program running, block search, loading machine data).
2. Startup has already been performed in the other program operating mode.
3. A channel has exited the mode group due to an interrupt.
4. Overstore or digitizing has been selected.
Remedy > Abort the program (Reset key) or stop the program (not with block search, loading
machine data).
> Abort the program (Reset key).
> Abort the program with the Reset key or wait until the interrupt has finished.
> Deactivate overstore/digitizing.
No. 6
Explanation Automatic change from an internal mode to the mode set externally (with TEACH_IN, an
attempt is made after every stop to change from the internal mode "AUTOMATIC, MDA"
to TEACH_IN).
Not allowed if -
Remedy -
To Next Page
Loading...
Need help?
General
