Siemens SINUMERIK 840D - Page 572

Overview of Alarms 11/2006
NCK alarms
2-572
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61908 Channel %1 block %2: No starting point specified
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61909 Channel %1 block %2: Helix radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61910 Channel %1 block %2: Helix violates contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61911 Channel %1 block %2: Several approach points required
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61912 Channel %1 block %2: No path to generate
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: --
Reaction: Alarm display.
Remedy: --
Program
Continuation:
Internal
61913 Channel %1 block %2: No residual material generated
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61914 Channel %1 block %2: Programmed helix violates contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61915 Channel %1 block %2: Approach/retract motion violates contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --