Siemens SINUMERIK 840D - Page 571

NCK alarms
11/2006 Overview of Alarms
2-571
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61900 Channel %1 block %2: No contour available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61901 Channel %1 block %2: Contour not closed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61902 Channel %1 block %2: No more memory available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61903 Channel %1 block %2: Too many contour elements
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61904 Channel %1 block %2: Too many intersections
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61905 Channel %1 block %2: Cutter radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The diameter of the cutter used is too small, residual material is left in the groove. Alarm triggered by
following cycles: SLOT2, CYCLE73, CYCLE74, CYCLE75.
Remedy: Use a tool with a larger radius.
61906 Channel %1 block %2: Too many contours
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61907 Channel %1 block %2: No center point specified for circle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.
Remedy: --