Siemens SINUMERIK 840D - Page 576

Overview of Alarms 11/2006
NCK alarms
2-576
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
62107 Channel %1 block %2: parameter %4 incorrectly defined for tool
monitoring in cycles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Alarm display.
Remedy:
Program
Continuation:
Clear alarm with the Delete key or NC START.
62108 Channel %1 block %2: error in function Tool monitoring in cycles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reaction: Alarm display.
Remedy:
Program
Continuation:
Clear alarm with the Delete key or NC START.
62180 Channel %1 block %2: Set rotary axes %4 [deg]
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Note on 62180 and 62181:
Sample display of the swivel angle to be set for a manual rotary axis in CYCLE800:
62181 "Set rotary axis B: 32.5 [grd]"
Remedy: Settable angles for manual rotary axes.
62181 Channel %1 block %2: Set rotary axis %4 [deg]
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Note on 62180 and 62181:
Sample display of the swivel angle to be set for a manual rotary axis in CYCLE800:
62181 "Set rotary axis B: 32.5 [grd]"
Remedy: Settable angle for manual rotary axis.
62182 Channel %1 block %2 : load inclinable head: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No swivel head is active. Alarm triggered by following cycles: E_TCARR, F_TCARR.
Reaction: Alarm display.
Remedy: Request to load a swivel head.
Program
Continuation:
Clear alarm with the Delete key or NC START.