Siemens SINUMERIK 840D - Page 577

NCK alarms
11/2006 Overview of Alarms
2-577
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
62183 Channel %1 block %2 : unload inclinable head: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Reaction: Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the Delete key or NC START.
62184 Channel %1 block %2 : replace inclinable head: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Reaction: Alarm display.
Remedy: --
Program
Continuation:
Clear alarm with the Delete key or NC START.
62185 Channel %1 block %2 : angle adapted to angle grid: %4
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: %4 difference angle with Hirth tooth system
Alarm triggered by following cycle: CYCLE800.
Remedy: Check installation and start-up of the swivel cycle CYCLE800.
62186 Channel %1 Block %2: Swiveling in JOG --> active WO G%4 and basic
frames contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE800.
Note for 62186 and 62187:
Set and active error messages 62186 and 62187 with GUD7 parameter _TC_FR:
100th position 0xx -> no error analysis 62186 61287
1xx -> error analysis 62186 - active WO G%4 and basic frames include rotations
2xx -> error analysis 62187 - several active basic frames (G500) include rotations
3xx -> error analyses 62186 and 62187.
Remedy: For %4 of the active WO see notes for 62186 and 62187.
62187 Channel %1 Block %2: Swiveling in JOG --> several active basic frames
(G500) contain rotations
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Several active basic frames (G500) include rotations.
Alarm triggered by following cycle: CYCLE800.
Note on 62186 and 62187
Setting of the activation of error messages 62186 and 62187 with GUD7 parameter _TC_FR:
100's place 0xx -> no error evaluation 62186 61287
1xx -> error evaluation 62186 - active NV G%4 and basic frames include rotations
2xx -> error evaluation 62187 - several active basic frames (G500) include rotations
3xx -> error evaluation 62186 and 62187
Remedy: See notes for 62186 and 62187.