EasyManuals Logo

Siemens SINUMERIK 840D Diagnostic Manual

Siemens SINUMERIK 840D
880 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #578 background imageLoading...
Page #578 background image
Overview of Alarms 11/2006
NCK alarms
2-578
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
62200 Channel %1 Block %2: Start spindle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Stop prior to thread machining, as the spindle is in stop position.
Alarm triggered by following cycles: ASUP, E_TR_CON, F_TR_CON.
Remedy: Start the tool spindle before machining the thread.
62201 Channel %1 block %2: Z offset does not influence the retraction planes.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The retraction planes refer to the workpiece. Therefore, programmable offsets do not influence the
retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Remedy: Ensure that the offset will not cause a collision.
Then start the NC.
The alarm can be suppressed via display machine data 9898.
62202 Channel %1 block %2: NOTICE: tool travels directly to machining!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After block search a position is to be reached by direct approach.
Alarm triggered by following cycle: F_TFS.
Remedy: Check whether the desired position can be reached without collision.
Then execute an NC start.
62300 Channel %1 Block %2: Check number of empirical value memory
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: --
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check setpoint value
Increase parameter _TSA
Program
Continuation:
Clear alarm with the RESET key. Restart part program
62303 Channel %1 Block %2: Safety margin exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm can be triggered by following measuring cycles: all measuring cycles.
Remedy: -Check setpoint value
-Increase parameter _TSA

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals