Siemens SINUMERIK 840D Diagnostic Manual

Overview of Alarms 11/2006
HMI alarms
2-608
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
100106 Error on saving
Definitions: This message will be displayed on editing a file (part program), if a memory operation could not be
performed correctly.
Reaction: Alarm display.
Remedy: If there is no memory space left in the NCK, it will not be possible to save anything. Other contents
(files, programs) must be deleted.
If the error occurs when the program is started immediately after the change, the changes will not
become effective. The program should be stopped immediately. The change must be repeated and
the program must be started after a small delay (approx. 1 sec.).
If the error occurs when a program is changed during execution, only a program reset will help.
100107 Error on opening %1
Parameters: %1 = --
Definitions: --
Remedy: --
100108 Write access not allowed in this state
Definitions: --
Remedy: --
100109 No block marked
Definitions: --
Remedy: --
100110 Read access not allowed in this state
Definitions: --
Remedy: --
100111 Actual changes not yet effective
Definitions: --
Remedy: --
100112 Search string '%1' found
Parameters: %1 = --
Definitions: --
Remedy: --
100113 Search string '%1' replaced by '%2'
Parameters: %1 = --
%2 = --
Definitions: --
Remedy: --
100114 Please wait, storing program (%1)!
Parameters: %1 = --
Definitions: --
Remedy: --

Siemens SINUMERIK 840D Specifications

General

Series	SINUMERIK 840D
Axes	Up to 31
Channels	Up to 10
Operating System	Windows-based
Power Supply	24 V DC
Control Unit Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
Interpolation	Spline
PLC	Integrated PLC
Data Storage	CompactFlash, USB