Siemens SINUMERIK 840D Diagnostic Manual

HMI alarms
11/2006 Overview of Alarms
2-619
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
100931 Settings have been saved
Definitions: --
Remedy: --
100932 !Error(file access): Cannot save
Definitions: --
Remedy: --
100933 Timeout: Semaphore not enabled
Definitions: --
Remedy: --
100934 Remote diagnostics: Error 10 -SendFileToRemote()- %1
Parameters: %1 = --
Definitions: --
Remedy: --
100935 Remote diagnostics: No response from remote PC (timeout)
Definitions: --
Remedy: --
100936 Remote diagnostics:Remote diag. port at default setting(5800)!
Definitions: --
Remedy: --
100937 Remote diagnostics: Connection established to %1
Parameters: %1 = --
Definitions: --
Remedy: --
100938 Delete a connection in menu Start-up>>Log.drive>>Conn.
Definitions: --
Remedy: --
101000 No connection to PLC !
Definitions: The connection to the PLC cannot be made while booting, e.g. wrong PLC basic program.
Remedy: --
101001 Cannot read PLC system status list !
Definitions: After the connection has been made, the system status list cannot be read.
Remedy: Switch controller off/on
101002 Password is not valid !
Definitions: The password entered is wrong.
Remedy: Enter a valid password.

Siemens SINUMERIK 840D Specifications

General

Series	SINUMERIK 840D
Axes	Up to 31
Channels	Up to 10
Operating System	Windows-based
Power Supply	24 V DC
Control Unit Type	CNC
Interface	Ethernet, PROFIBUS
Display	TFT color display
Interpolation	Spline
PLC	Integrated PLC
Data Storage	CompactFlash, USB