Overview of Alarms 11/2006
HMI alarms
2-620
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
101003 Password has been set for %1 !
Parameters: %1 = Access-level system, manufacturer, service or user.
Definitions: The password for system, manufacturer, service or user was set successfully.
Remedy: --
101004 Password has been changed for %1 !
Parameters: %1 = Access-level system, manufacturer, service or user.
Definitions: The password for system, manufacturer, service or user was changed successfully.
Remedy: --
101005 Passwords do not correspond !
Definitions: When the password was changed, the password entered first does not match the one entered second.
Remedy: Enter a valid password.
101006 Password has been deleted !
Definitions: The password was deleted via the softkey "Delete password".
Remedy: Enter password.
101007 Password has not been set !
Definitions: To delete the password, a higher access authorization is required (at least user).
Remedy: Set the password with a higher access level.
101008 Current access level: %1
Parameters: %1 = Access-level system, manufacturer, service or user.
Definitions: When selecting the alarm image, the current access level is displayed: system, manufacturer, service
or user or keyswitch positions 3/2/1/0.
Remedy: --
101013 Input error - see Help key (i)
Definitions: PLC status A syntax error occurred while entering a value in the PLC status.
The input syntax is explained in a help image.
Remedy: --
101014 Error on reading PLC-data !
Definitions: --
Remedy: --
101015 Error on writing PLC-data !
Definitions: --
Remedy: --
101016 Error: Operand address greater than 65535 !!
Definitions: The value range of the operand address was exceeded.
Remedy: Use a smaller value range for the operand address.
101017 No PLC input masks found !
Definitions: There are no *.plc input masks in the target system.
Remedy: --
To Next Page
Loading...
Need help?
General
