HMI alarms
11/2006 Overview of Alarms
2-651
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
105042 Block number not allowed !
Definitions: The first block number is less than 0 or greater than 999999.
Remedy: --
105043 Increment not allowed !
Definitions: The increment was entered as a negative.
Remedy: --
105050 Please wait: graphics being output !
Definitions: The help displays are being prepared for display.
Remedy: --
105051 %1
Parameters: %1 = --
Definitions: The dynamic long texts for the cycle parameterization are output here.
Remedy: --
105052 Error in description of cycles of %1 !
Parameters: %1 = --
Definitions: The cycle description sc.com, uc.com contains a line that cannot be interpreted.
This line is output via <xxx>.
Remedy: --
105053 No cycle available in current line !
Definitions: The editor's cursor is in a line that does not contain a cycle.
A recompilation is not possible.
Remedy: --
105054 Error on calling of description of cycles !
Definitions: One of the sc.com, cov.com cycle description files contains a non-interpretable parameter.
Initilization of the cycles is aborted.
Remedy: --
105060 Please wait: initialization of cycles support
Definitions: The cycle description files are interpreted and prepared for display on the screen.
Remedy: --
105061 Error on opening of file %1 !
Parameters: %1 = --
Definitions: The specified file could not be opened.
System-internal error that does not occur in normal operation.
Remedy: --
105062 Error on closing of file %1 !
Parameters: %1 = --
Definitions: The specified file could not be closed.
System-internal error that does not occur in normal operation.
Remedy: --
To Next Page
Loading...
