Siemens SINUMERIK 840D - Page 663

HMI alarms
11/2006 Overview of Alarms
2-663
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
112301 Tool management concept 2 not possible%nMagazine not sorted like
tool list.
Definitions: The magizine list sorting does not correspond to that of the tool list.
-
Reaction: Alarm display.
Remedy: Installation and start-up: Assign the tools according to their T numbers to the magazine locations.
Program
Continuation:
Internal
112320 Replace manual tool:%n%1.
Definitions: The operator is prompted to replace the indicated manual tool.
Reaction: Alarm display.
Remedy: Replace the manual tool.
Program
Continuation:
Internal
112321 Load manual tool:%n%1.
Definitions: The operator is prompted to load the specified manual tool.
Reaction: Alarm display.
Remedy: Load the manual tool.
Program
Continuation:
Internal
112322 Exchange manual tool:%n%1 -> %2.
Definitions: The operator is prompted to replace the specified manual tool by the new manual tool.
Reaction: Alarm display.
Remedy: Replace the manual tool.
Program
Continuation:
Internal
112323 Replace inclinable head:%n%1
Definitions: The operator is prompted to remove the specified swivel head from the spindle.
Reaction: Alarm display.
Remedy: Replace swivel head.
When doing this, please follow the machine manufacturer's instructions.
Program
Continuation:
Internal
112324 Load inclinable head:%n%1
Definitions: The operator is prompted to load the specified swivel head into the spindle.
Reaction: Alarm display.
Remedy: Load swivel head.
When doing this, please follow the machine manufacturer's instructions.
Program
Continuation:
Internal