Overview of Alarms 11/2006
HMI alarms
2-664
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
112325 Exchange inclinable head:%n%1 -> %2
Definitions: The operator is prompted to replace the specified swivel head in the spindle with the new swivel head.
Reaction: Alarm display.
Remedy: Exchange swivel head.
When doing this, please follow the machine manufacturer's instructions.
Program
Continuation:
Internal
112326 Set inclinable head%n%1%2
Definitions: The operator is prompted to set the swivel head in accordance with the specified data.
Reaction: Alarm display.
Remedy: Set swivel head.
When doing this, please follow the machine manufacturer's instructions.
Program
Continuation:
Internal
112327 Angle not in allowed area:%n%1%2
Definitions: The programmed machining cannot be carried out with the swivel head.
Reaction: Alarm display.
Remedy: If necessary, clamp the workpiece differently.
Program
Continuation:
Internal
112328 Angle adapted to angle grid:%n%1%2
Definitions: Due to the angle grid, the swivel head could not be set exactly to the specified angle.
Reaction: Alarm display.
Remedy: Machining can be continued with the specified values, but it will not correspond exactly to the
programming.
Program
Continuation:
Internal
112329 Set inclinable head/swivel table:%n%1%2
Definitions: The operator is prompted to set the swivel head/table in accordance with the specified data.
Reaction: Alarm display.
Remedy: Set swivel head/table.
When doing this, please follow the machine manufacturer's instructions.
Program
Continuation:
Internal
112330 Set swivel table:%n%1%2
Definitions: The operator is prompted to set the swivel table in accordance with the specified data.
Reaction: Alarm display.
Remedy: Set swivel table.
When doing this, please follow the machine manufacturer's instructions.
Program
Continuation:
Internal
To Next Page
Loading...
