Siemens SINUMERIK 840D - Page 28

B500
B500 Page 26 840D/828D SINUMERIK Operate
Notes
Milling Section 5
Unit
DX1
(Engraving)
Character spacing or total width
(only for linear alignment)
mm
DX
Maximum depth infeed mm
DXY
Maximum plane infeed
Alternatively the plane infeed can also be stated
as a percentage ratio of plane infeed (mm) to the
milling cutter diameter (mm)
mm
%
DY1
(Engraving)
Character spacing or total width
(only for linear alignment)
Machining the mantle
mm
DYZ
Maximum plane infeed
Alternatively the plane infeed can also be stated
as a percentage ratio of plane infeed (mm) to the
milling cutter diameter (mm)
mm
%
DZ
Maximum depth infeed
(only for roughing)
mm
Plunging
(Rectangular
pocket)
(Longitudinal
slot)
(Pocket
milling)
Vertical:
Vertical plunging to the pocket centre
Helical:
Plunging along a spiral path
Oscillating:
Plunging with an oscillating motion along the
central axis of the rectangular pocket.
Plunging
(Circular
pocket)
Vertical:
Vertical plunging at the centre of pocket.
Helical:
Plunging along a spiral path
EP
(Rectangular
/circular
pocket)
Maximum pitch of the helix
(only for helical plunging)
mm/rev