Siemens SINUMERIK 840D - Page 29

840D/828D SINUMERIK Operate Page 27
B500
B500
Notes
Milling Section 5
Unit
ER
(Rectangular
/circular
pocket)
Radius of the helix
(only for helical plunging)
mm
EW
(Rectangular
pocket)
(Longitudinal
slot)
Maximum plunge angle
(only for oscillatory plunging)
Degrees
F
Feed mm/min
mm/rev
FR
(Path milling)
Retraction feed for intermediate positioning
Milling
direction
(Open slot)
Milling direction (other than plunge milling)
Climb milling
Conventional milling
FS
(Rectangular
/circular
pocket)
(Rectangular
/circular
spigot)
(Path milling)
Chamfer width for chamfering
(only for chamfering)
mm
FX
(Rectangular
/circular
pocket)
(Longitudinal
slot)
Infeed feed depth
(only for vertical and pre-drilled plunging)
for mantle C/Y
mm/min
mm/tooth
FZ
(Rectangular
/circular
pocket)
(Longitudinal
slot)
Infeed feed depth
(only for vertical and pre-drilled plunging)
for front C/Y
mm/min
mm/tooth
Engraving
text
(Engraving)
Maximum 100 characters
H1
(Thread-
milling)
Thread depth mm