B618
B618 Page 6 840D/828D SINUMERIK Operate
Notes
Simple programming example
Section 2
8. Insert the following G code commands into the pro-
gram and program the program end:
N190 G0 X200 Z200
N200 M30
9. At the end, simulate the machining.
Press the HSK 1.7 “Simulation” to start the simula-
tion of the program.
The simulation starts in a “Side view” on the blank by
default.
To see the simulation of the machining from the front
of the blank, press the VSK 1.4 “Face view”.
To Next Page
