Siemens SINUMERIK 840D - Page 425

840D/828D SINUMERIK Operate
Notes
4. Insert a tool into the program.
Press the VSK 1.1 “Select tool”.
The tool list window opens.
Select the tool “CUTTER_D8” by using the blue cur-
sor key on the keyboard.
Press the VSK 1.1 “To program”.
The G code command N130 T="CUTTER_D8"
Is inserted into the program.
Optionally you can program this line by hand..
5 Program now the following G code commands:
N140 M6
N150 SETMS(2)
N160 M24
N170 S4500 M3
6. Program the milling cycle (CYCLE79) for the multi-
edged spigot .
For this press the HSK 1.5 “Mill.” to open the tech-
nology “Milling”.
Press the VSK 3 “Multi-edge spigot”.
Press the VSK 5 “Multi-edge”.
The input mask for the milling cycle “Multi-edge”
opens.
7. Insert the following values into the parameter mask
for the multi-edge:
The following line for the CYCLE79 is inserted into te
program:
N180 CYCLE79(100,0,1,-5,6,75,0,0,0,1,100,80,
2.5,0,0,500,0,1,1,2,,1,111)
Section 2
Simple programming example