B626
B626 Page 18 840D/828D SINUMERIK Operate
Notes
The following program line will be inserted into the
program:
N320 CYCLE952("FINISHING",,"",2301321,
0.12,0,0,1.9,0.1,0.1,0.2,0.2,0.1,0,3,0,0,,,,,2,2,,,0,1,,0,
12,1100110)
30. Program the following two lines:
N330 G0 X200 Z200
N340 M30
31. Program now the contour and insert the first contour
description (SPIGOT_BLANK) into the program.
Press the VSK 1 “Contour”.
The vertical softkey bar with functions for creating
and calling up a contour opens.
Press the VSK 1 “New contour” to create a new con-
tour.
The input mask for entering a name for the new con-
tour opens.
32. Enter the following name for the new contour:
Confirm your input by pressing the VSK 8 “Accept”.
The following screen opens, where you can set the
starting point of the contour.
Section 3
Complex programming example
To Next Page
