Siemens SINUMERIK 840Di - Page 553

NCK alarms
11/2006 Overview of Alarms
2-553
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61505 Channel %1 block %2: retraction path < 1mm
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420
Remedy: Increase retraction path
61506 Channel %1 block %2: infeed path < 1mm
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420
Remedy: Increase infeed path
61507 Channel %1 block %2: safety clearance < 1mm
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: setup function
Remedy:
61508 Channel %1 block %2: Incorrect default setting for shoulder position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: setup function
Remedy:
61509 Channel %1 block %2: Incorrect default setting for dresser position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: setup function
Remedy:
61510 Channel %1 block %2: Test run feed is active
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE413,
CYCLE415, CYCLE420
Remedy: Switch off test run feed
61511 Channel %1 block %2: Incorrect shoulder position or tool edge D1/D2
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: setup function
Remedy: