Siemens SINUMERIK 840Di - Page 554

Overview of Alarms 11/2006
NCK alarms
2-554
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61512 Channel %1 block %2: Incorrect longitudinal position
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: setup function
Remedy:
61513 Channel %1 block %2: Dresser left and inclined grinding wheel
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: setup function
Remedy:
61514 Channel %1 block %2: Grinding wheel type missing
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: setup function
Remedy:
61515 Channel %1 block %2: Retraction path <= dressing amount
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: CYCLE416
Remedy: Change retraction path
61517 Channel %1 block %2: Angle of inclined grinding wheel missing
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: CYCLE416
Remedy: Enter angle under $TC_TPG8
61518 Channel %1 block %2: Shoulder height of grinding wheel must be >
grinding wheel radius
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycle: CYCLE432
Remedy: Change shoulder height or grinding wheel radius
61519 Channel %1 block %2: Incorrect type of machining
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE412,
CYCLE413, CYCLE415
Remedy: Assign a value between 1 and 3 to parameter B_ART
61520 Channel %1 block %2: Additional offsets not set
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: The alarm can be triggered by the following grinding cycles: CYCLE413, CYCLE420, CYCLE433
Remedy: Set MD18094 MM_NUM_CC_TDA_PARAM=10