HMI alarms
11/2006 Overview of Alarms
2-637
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
104004 No active workpiece available
Definitions: After pressing the softkey "Current T+D No." in the "Tool overview" window, no tool was found
because no subroutine is active or in the active subrutine no tool is selected.
Remedy: Select a tool.
104005 There is no active cutting edge
Definitions: A tool has been selected, but not a cutting edge.
Remedy: Select a cutting edge.
104006 No TO area available in current channel
Definitions: No TO area is assigned to the current channel.
Remedy: Assign the current channel a TO area via the machine data, or switch channels.
104007 Error on creating tool
Definitions: The tool could not be created, as, for example, the maximum number of possible tools has already
been reached.
Remedy: Extend the maximum number of tools via the machine data, or delete unnecessary tools.
104008 Error on creating tool edge
Definitions: No new cutting edge could be created, as, for example, the maximum number of cutting edges has
already been reached.
Remedy: Delete unnecessary cutting edges.
104009 Error while writing tool type
Definitions: --
Remedy: --
104010 Error while writing tool position
Definitions: --
Remedy: --
104011 Error on deleting tool
Definitions: The tool cannot be deleted. It may currently be active.
Remedy: --
104012 No master spindle available
Definitions: No master spindle was configured.
Remedy: Configure a master spindle via the machine data.
104013 Error on deleting area
Definitions: --
Remedy: --
104014 Incorrect input
Definitions: The entered value is impermissible, e.g., it lies outside the input limits.
Remedy: Please observe the value range.
To Next Page
Loading...
