Overview of Alarms 11/2006
HMI alarms
2-638
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
104015 Number of parameters per tool edge is zero
Definitions: The number of parameters per cutting edge was not configured.
Remedy: Configure the number of parameters per cutting edge via the machine data.
104016 No spindles available
Definitions: No spindle was configured.
Remedy: Configure a spindle via the machine data.
104017 No settable frame currently active
Definitions: --
Remedy: --
104018 Tool not available
Definitions: The specified tool does not exist.
Remedy: --
104019 Tool type not available
Definitions: The specified tool type does not exist.
Remedy: Specify a valid tool type.
104020 No empty location found
Definitions: There is no empty location with the specified search parameters.
Remedy: Correct search parameters.
104021 Error on searching for empty location
Definitions: --
Remedy: --
104022 Error in present location search
Definitions: --
Remedy: --
104023 Error in Tool Load
Definitions: An error occurred while a tool was being loaded; the procedure has been aborted.
Remedy: Check loader.
104024 Error in Tool Unload
Definitions: An error occurred while a tool was being unloaded; the procedure has been aborted.
Remedy: Check unloader.
104025 No magazine configured
Definitions: No magazine was configured.
Remedy: Configure a magazine via the machine data.
104026 NOTICE! Tool Load running!
Definitions: Note regarding loading process.
Remedy: Wait until the loading procedure is terminated.
To Next Page
Loading...
