Siemens sinumerik fm-nc - Page 155

6 Assi
g
nin
g
Parameters to the Control and the PLC Pro
g
ram
6
03.96
6.10 Linear motors (1FN1 and 1FN3 motors)
6-155
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
2. Adapt the axis-specific machine data (MD) as for feed drive
Fig. 6-26 Minimum selection of axis machine data for linear motor
04.00