Set-up
14
Building Technologies
Fire Safety & Security Products 06.2009
4.5 Entering characters
Several parameters allow/require that both digits and letters can be entered when
setting up the InfoPoint. The buttons to the right of the screen are used for navigat-
ing the cursor as well as choosing the character.
The “minus” buttons furthest to the left navigate up/down amongst the parameters
and the top “plus/minus” buttons move the cursor left/right. The “Backspace” button
erases one character and moves the cursor left.
When the cursor is in the correct position the “plus” buttons to the right are used for
scrolling through the character set. The current character is shown in the cursor
while the character before/after is displayed in the button symbols on the screen.
By moving the cursor right or left the character has been confirmed.
1. Move cursor left
2. Move cursor right
3. Choose next character
4. Choose previous character
5. Parameter up
6. Parameter down
The illustration shows how “2” is the current character and “1” or “3” can be se-
lected with the “plus” buttons to the right.
To Next Page
Loading...
