[front-7sj80-mit-abdeckungen-20071107, 1, --_--]
Figure 3-11 Housing with covers
[front-7sj80-ohne-abdeckungen-20071107, 1, --_--]
Figure 3-12 Housing with fixing holes (without covers)
Panel Flush Mounting
The housing (housing size
1
/
6
) has 2 covers and 4 fixing holes.
•
Remove the 2 covers at the top and bottom of the front cover. Thus, 4 elongated holes are revealed in
the mounting bracket and can be accessed.
•
Insert the device into the panel cut-out and fasten it with four screws. For dimensional drawings, refer to
Section 4.25 Dimensions.
•
Mount the 2 covers again.
3.1.3.2
Mounting and Commissioning
3.1 Mounting and Connections
324 SIPROTEC 4, 7SJ80, Manual
E50417-G1140-C343-A8, Edition 12.2017
To Next Page
Loading...
