PROFIBUS-DP - Parameterization in DIGSI
62
SIPROTEC PROFIBUS-DP - Communication profile
C53000-L1840-B001-03
Note:
Please, edit only the numbers in the rows which do not start with “//” and note the
semicolons at the end of the line.
Editing anything else in the “Changeable area:” may cause an error when closing the
Properties - SIPROTEC 4 device dialog window.
Attention!
If after change of a measured value’s scaling (ref. to chap. 4.3) a bus specific param-
eter is changed then all scalings are reset to their defaults according to the bus map-
ping documents (ref. to page 3) again.
To Next Page
Loading...
Need help?
General
