Fig. 4: Horizontal installation (recommended installation position, especially for
adhesive products)
1 Switching point
2 Marking with screwed version on top, with flange versions directed to the
flange holes
With flange versions, the fork is directed as follows to the flange holes.
Fig. 5: Fork position with flange versions
Use the recommended cables (see chapter "Connecting to power
supply") and tighten the cable gland.
You can give your SITRANS LVL200E additional protection against
moisture penetration by leading the connection cable downward in
front of the cable entry. Rain and condensation water can thus drain
off. This applies mainly to outdoor mounting as well as installation in
areas where high humidity is expe cted (e.g. through cleaning
processes) or on cooled or heated vessels.
Moisture
12 SITRANS LVL200E - CONTACTLESS ELECTRONIC SWITCH
4 Mounting
33839-EN-100908
To Next Page
Loading...
