en Fault, what to do?
30
Spray arms
Limescale and contaminants in the
rinsing water may block nozzles and
bearings on the spray arms 1: and
1J.
1. Check outlet nozzles on the spray
arms for blockages.
2. Unscrew the upper spray arm 1:.
3. Remove the lower spray arm 1J
upwards.
4. Clean spray arms under running
water.
5. Re-engage or screw on spray arms.
3 Fault, what to do?
Fault, what to do?
Experience has shown that you can
rectify most faults which occur in daily
operation yourself. This ensures that
the machine is quickly available to you
again. In the following overview you can
find possible causes of malfunctions
and helpful information for rectifying
them.
Note
If the appliance stops during
dishwashing or does not start for no
obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled “Operating
the appliance”)
m Warning – Don’t forget: Repairs may
be carried out by technicians only. If a
component has to be replaced, ensure
that only original spare parts are used.
Improper repairs or use of non-original
spare parts may cause considerable
damage and put the user at
considerable risk.
To Next Page
Loading...
Need help?
General
