Siemens SN... - Detergents with Salt Component; Rinse Aid; Switching off Water Softening System

Rinse aid en
11
3. Then add dishwasher salt (not table
salt or tablets).
The water is displaced and runs out.
As soon as the salt refill indicator @
on the fascia is lit, top up the salt.
* depending on model
Using detergents with salt
component
Detergents with salt component
If combined detergents with a salt
component are used, salt can usually be
omitted up to a water hardness of
21° dH (37° fH, 26° Clarke, 3.7 mmol/
l). If the water hardness is over 21° dH,
special salt must be used.
Switching off salt refill
indicator/water softening
system
Switchin g off water softening system
If the salt refill indicator @ is impaired
(e.g. when using combined detergents
containing salt component), it can be
switched off.
ヽ Proceed as described under
“Adjusting the water softening
system” and set the value to •:‹‹.
The water softening system and salt
refill indicator are now switched off.
ã Caution
Never fill the salt dispenser with
detergent. You will destroy the water
softening system.
, Rinse aid
Rinse aid
As soon as the rinse-aid refill
indicator H is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 9" by pressing
and lifting the plate on the cover.



www.devicemanuals.eu/
component are used, salt can usually be
www.devicemanuals.eu/
component are used, salt can usually be
21° dH (37° fH, 26° Clarke, 3.7 mmol/
www.devicemanuals.eu/
21° dH (37° fH, 26° Clarke, 3.7 mmol/
l). If the water hardness is over 21° dH,
www.devicemanuals.eu/
l). If the water hardness is over 21° dH,
Switching off salt refill
www.devicemanuals.eu/
Switching off salt refill
indicator/water softening
www.devicemanuals.eu/
indicator/water softening
The rinse aid is required for stain-free
www.devicemanuals.eu/
The rinse aid is required for stain-free
utensils and clear glasses. Use only
www.devicemanuals.eu/
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
www.devicemanuals.eu/
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
www.devicemanuals.eu/
Combined detergents with rinse-aid
component may be used up to a water
www.devicemanuals.eu/
component may be used up to a water
hardness of 21° dH (37° fH,
www.devicemanuals.eu/
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
www.devicemanuals.eu/
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
www.devicemanuals.eu/
the water hardness is over 21° dH,
rinse aid must be used.
www.devicemanuals.eu/
rinse aid must be used.
1.
www.devicemanuals.eu/
1.