Siemens SPC4000 Installation & Configuration Manual

Engineer Programming Via the Keypad
48
Siemens Building Technologies
Fire Safety & Security Products 09.2008
Variable Description Default
SMS AUTH MODE This variable indicates the login procedure required for SMS functionality.
PACE AND PIN This variable determines the login requirements for a user.
RESTORE ON
UNSET
This variable allows user to unset and restore alarm functionality at the same time.
OFFLINE TAMPER This creates a tamper for when zones are offline.
Tab. 6 Variables and Descriptions
NOTE
The programming options displayed in the VARIABLES menu vary depending on the security grade of
the system.
This section provides programming steps found within Variables using the Keypad.
For each menu option, the Keypad must be in Full Engineer programming and
within the first menu option VARIABLES:
1. Enter the Engineer Programming code (default
1111).
2. Press SELECT for FULL ENGINEER
programming.
3. Using the up and down arrow keys, scroll to
VARIABLE programming option.
Î An ellipsis (…) on accompanying graphics
denotes when there is a choice of menu
selection by scrolling.
Î Upon completion of the programming options, the Keypad displays UPDATED
momentarily.
10.3.1 Security Grade
To program the security grade details:
1. Scroll to SECURITY GRADE programming
option.
2. Press SELECT and choose from one of the 3
security grade options:
– Grade 2 (Conforms to Security Grade 2
requirements)
– Grade 3 (Conforms to Security Grade 3
requirements)
– Engineer configure (When a system is in
Grade 2 or Grade 3 and the engineer selects
engineer configure the system remains compliant to previous grade setting.
Once options are changed under Engineer configure, the system may or
may not be compliant. Any changes away from standards should be noted
as deviation and agreed with end customer.)
If Grade 2 or 3 is selected, a list of countries is displayed; the country setting of the
system sets the market specific security requirements for the installation in
accordance with the country specific standards [2], [3].
3. Scroll to the appropriate country setting: IRELAND, EUROPE, or UK and
press SAVE.
FULL ENGINEER
EXIT
SELECT
UPDATED
...VARIABLES...
BA
C
K
S
ELE
C
T
SECURITY GRADE
BACK
SELECT
...IRELAND...
BA
C
K
S
AVE
...GRADE 2...
BA
C
K
S
ELE
C
T

Siemens SPC4000 Specifications

General

Brand	Siemens
Model	SPC4000
Category	Control Panel
Language	English