11
en
Note: You may notice a „new machine“
with a vinegar solution (1 cup of vinegar
for 5 cups of water) and run the cleaning
program. Next, rinse the machine twice with
six cups of water.
Clean the carafe thoroughly.
Remove the water tank 1
and replace it.
3.
4
3 and let it
engage.
Place the carafe 6 with the lid closed
3.
Press button 10 start to begin the
brewing process.
J or L lights up depending on the
volume of water in the tank. At the same
time, the function is activated.
TC863.. only
Info: The appliance has an automatic
(power save) function, which
switches the appliance to power-saving
mode around 40 minutes after the brewing
process is complete.
TC865.. only
Info: The appliance has an automatic
(power save) function, which
switches the appliance to power-saving
mode a few minutes after the brewing
process is complete.
Tip: If you rinse out the thermos carafe
stay warm even longer.
Important: When the brewing process
is complete, wait a moment until all the
carafe.
minutes before brewing a fresh pot.
Timer function
timer.
It lets you set the time at which the machine
will automatically start the brewing process.
The timer works only if the machine is
turned on or in power-save mode.
The clock must be set to the correct
current time.
Press and hold down the button 16 prog
while programming the timer (Fig. a).
Use button 14 h to set the hour and
button 15 min to set the minute at
which you want the brewing to start
(Figs. b and c).
Release button 16 prog to save the
start time. The display 13 shows a little
clock V to indicate that the timer function
is activated.
usual and place the carafe 6 under the
3.
The brewing process will start auto-
matically at the set time; the little clock V
disappears.
Note: To check the programmed time,
press and hold down the button 16 prog.
Press button 16 prog. If the little clock
lights up, the timer function is on. If the little
clock V
Note:
with switch 7 or the power supply is inter-
rupted (plug not plugged in, power failure),
the clock and timer settings will be stored
for approximately four days. If the power
interruption lasts longer, you must reset the
clock.
To Next Page
Loading...
