14
en
The machine automatically releases water
into the container and vacuums it up again
via the milk tube to rinse the milk system�
The rinse procedure stops automatically
after about 1 minute�
Empty the container and clean the milk
tube (6c)�
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher)�
Dismantling the milk system for cleaning:
Pull the milk frother (6) forward out of the
appliance�
Dismantle the milk frother into its indi-
vidual parts (6a to 6d) (see gure C at
the start of the operating instructions)�
Clean the individual parts with a detergent
solution and a soft brush� If necessary,
soak in a warm detergent solution�
Rinse all parts with clear water and dry
them�
Reassemble all the parts and replace fully
in the appliance�
A Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed�
Cleaning the brewing unit
Clean the brewing unit regularly!
To pre-clean the brewing unit automatically:
Select k by turning the rotary knob (15)�
Place an empty glass under outlet (6a)�
Press the start button (10)�
The appliance rinses�
In addition to the automatic cleaning
programme, the brewing unit (5a) should
be removed regularly for cleaning� (See
gure E at the start of the operating
instructions�)
Switch the appliance off at the power on/
off switch O / I (9)� No buttons are lit�
Open the door (5b) to the brewing unit�
Slide the red lock (5e) on the brewing unit
(5a) completely to the left�
Press the eject lever (5d) down fully� The
brewing unit is released�
Grasp the brewing unit (5a) by the
recessed grips and remove carefully�
To Next Page
Loading...
