Siemens TE515 - Cleaning Procedure; CalcnClean Program

17
en
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue� Such residue can
cause corrosion� New sponge cloths may

on stainless steel and must therefore be
washed out thoroughly before use�
Cleaning
Duration: approx� 10 minutes�
If the message Clean required! appears
on the display, press the k off / i button
(13) for 3 seconds and then press the start
button (10)�
The cleaning programme will start�
To clean the appliance before being
prompted, press the k off / i button (13) for
at least 3 seconds� Then press the k off / i

rotary knob (15) until Start cleaning appears
in the display� To start the cleaning proce-
dure, press the start button (10)� The display
will guide you through the programme�
Empty drip tray
Insert drip tray
 Empty drip tray (8) and replace them�
Open drawer
 Open the drawer (4)�
Fill cleaner
Press start
 Drop a Siemens cleaning tablet in the
drawer (4) and close�
 Press the start button (10)�
Cleaning in progress
The cleaning pro gramme will now run for
about 8 minutes�
Empty drip tray
Insert drip tray
 Empty drip tray (8) and replace them�

ready for use again�
Calc‘n‘Clean
Duration: approx� 35 minutes�
Calc‘n‘Clean combines the separate func-
tions of descaling and cleaning� If both
programmes are due to be run soon, the
espresso machine automatically suggests
this service programme�
Important:
tank (17), it needs to be removed before the
service programme is run�
If the message Calc‘n‘Clean required!
appears on the display, press the k off / i
button (13) for 3 seconds and then
press the start button (10)� The service
programme will start�
To run Calc‘n‘Clean before being prompted,
press the k off / i button (13) for at least
3 seconds� Then press the k off / i button

knob (15) until Start Calc‘n‘Clean appears
in the display� To start Calc‘n‘Clean, press
the start button (10)�
The display will guide you through the
programme�
Empty drip tray
Insert drip tray
 Empty drip tray (8) and replace them�
Open drawer
 Open the drawer (4)�
Fill cleaner
Press start
 Drop a Siemens cleaning tablet in the
drawer (4) and close�
 Press the start button (10)�
N.B.:

press the start button (10) again� Remove the

Press the start button (10)�