21
en
Problem Cause Solution
Restore the unit to its
original factory settings
(“Reset”)�
You changed some
settings and want to
discard them�
Turn off the unit with the power
on/off switch O / I (9)� Press and
hold the k off / i (13) and the l
(12) button and turn the appliance
on with the power on/off switch
O / I
start button start (10)� The factory
settings are now activated�
Display shows
Refill beans! although the
bean container (1) is full,
or the grinding unit does
not grind the beans�
Beans are not falling into
the grinding unit
(beans too oily)�
Gently tap the bean container (1)�
Change the type of coffee if
necessary�
When the bean container (1) is
empty, wipe it with a dry cloth�
Display shows
Insert brewing unit
Brewing unit (5) is missing
or was not recognised�
Switch off the appliance with the
brewing unit (5) in place, wait
three seconds and switch on the
appliance�
Display shows
Clean brewing unit
Brewing unit (5) is soiled� Clean brewing unit (5)�
Too much pre-ground
coffee in the brewing
unit (5)�
Clean brewing unit (5)�
Pour in no more than 2 level
measuring spoons of ground
coffee�
The brewing unit’s
mechanism is stiff�
Remove and clean the brewing
unit, see “Maintenance and daily
cleaning”�
Display shows
Check water tank
Water tank wrongly
inserted�
Insert water tank correctly�
Carbonated water in the
water tank�
Fill the water tank with fresh tap
water�
Float is stuck in the water
tank�
Remove the tank and clean
thoroughly�
rinse according to the
instructions�
instructions and then switch on�
until no more air bubbles escape,
Display shows
Restart required
Appliance is too warm� Leave the appliance to cool down�
Brewing unit is soiled� Clean the brewing unit�
Display shows
Error
Call hotline
The appliance has a fault� Please call the hotline�
If you are unable to solve the problem, always call the hotline!
You will nd the telephone numbers at the back of these instructions.
To Next Page
Loading...
