Do you have a question about the Siemens ULTRAMAT 6E and is the answer not in the manual?
Protection Class | IP54 |
---|---|
Measurement Principle | NDIR absorption |
Measured Components | CO, CO2, CH4, NO, SO2 |
Measured Values | Gas concentration |
Measuring Ranges | Adjustable |
Response Time | Less than 10 seconds |
Operating Temperature | 0°C to +45°C |
Power Supply | 100 to 240 V AC, 48 to 63 Hz |
Outputs | 4-20 mA, relays |
Communication Interfaces | RS-232, RS-485, Ethernet |
Display | LCD |
Safety guidelines for maintenance of analyzers in hazardous areas.
Safety information specific to the CALOMAT 6E in hazardous areas.
Safety information specific to the ULTRAMAT 23 in hazardous areas.
Safety considerations for analyzers used in biogas plants.
Details on how to connect the power supply to the device.
Instructions for connecting signal lines to the device.
Specific instructions for connecting the PROFIBUS DP interface.
Specific technical specifications for the ULTRAMAT 23 analyzer.
Specific technical specs for ULTRAMAT 6E and ULTRAMAT/OXYMAT 6E.
Specific technical specs for OXYMAT 6E, OXYMAT/ULTRAMAT 6E, OXYMAT 61.
Specific technical specifications for the OXYMAT 64 analyzer.
Specific technical specifications for the CALOMAT 6E analyzer.
Specific technical specifications for the CALOMAT 62E analyzer.
Specific technical specifications for the FIDAMAT 6 analyzer.