To Next PageTo Next PageWhat to do if Siemens Measuring Instruments show no flow signal because current output exceeds 24 mA?
If the Siemens Measuring Instruments show no flow signal and the current output exceeds 24 mA, verify the maximum setting in BASIC SETTINGS.
What to do if Siemens Measuring Instruments show no flow signal because flow > 2 x Qmax.?
If the Siemens Measuring Instruments show no flow signal because the flow is greater than 2 x Qmax, verify the maximum setting in BASIC SETTINGS.
How to troubleshoot an empty display on Siemens SITRANS F US SONOFLO SONO 3000 Measuring Instruments?
If the Siemens Measuring Instruments display is empty, first check the supply voltage and voltage selector. If the issue persists, the SONO 3000 may be defective and need replacement.
What to do if Siemens Measuring Instruments show no flow signal because frequency/pulse output exceeds 12000 Hz?
If the Siemens Measuring Instruments show no flow signal and the frequency/pulse output exceeds 12000 Hz, verify the maximum setting in BASIC SETTINGS.
What to do if Siemens SITRANS F US SONOFLO SONO 3000 show no flow signal because of reverse flow direction?
If the Siemens Measuring Instruments show no flow signal due to a reverse flow direction, select FLOW DIRECTION in BASIC SETTINGS.
What to do if Siemens SITRANS F US SONOFLO SONO 3000 Measuring Instruments show no flow signal because pulse width on frequency output exceeds limit by 50%?
If the Siemens Measuring Instruments show no flow signal and the pulse width on the frequency output exceeds the limit by 50%, select a shorter pulse width.
What to do if Siemens Measuring Instruments show no flow signal because forced output redefined in the menu?
If the Siemens Measuring Instruments show no flow signal because of a forced output redefined in the menu, remove the cause of any additional errors. This code should then disappear.
What to do if Siemens SITRANS F US SONOFLO SONO 3000 show no flow signal because sound velocity value outside the measuring range?
If the Siemens Measuring Instruments show no flow signal because the sound velocity value is outside the measuring range, check the settings for track length and min./max. sound velocity.
What to do if Siemens SITRANS F US SONOFLO SONO 3000 Measuring Instruments show no flow signal because of hardware fault?
If the Siemens Measuring Instruments show no flow signal because of a hardware fault, replace the SONO 3000.
What to do if Siemens Measuring Instruments show no flow signal because SENSORPROM® unit defective?
If the Siemens Measuring Instruments show no flow signal and the SENSORPROM® unit is defective, remove the SENSORPROM® unit and enter the settings manually.
General| Measurement Principle | Ultrasonic |
|---|---|
| Pressure Rating | Up to 40 bar |
| Power Supply | 24 V DC |
| Housing Material | Aluminum, stainless steel |
| Accuracy | ±1% of reading |
| Temperature Range | -40°C to +200°C |
| Output Signal | 4-20 mA |
| Enclosure Protection | IP67 |
| Process Connection | Flanged |
| Communication | HART |
| Application | Liquids |
| Measurement Range | 12 m/s |
| Lining Material | Not applicable |
| Electrode Material | Not applicable |
Lists the included components for the remote installation of the signal converter.
Provides technical drawings and measurements for the signal converter and mounting hardware.
Illustrates the setup for mounting the device horizontally on a pipe.
Illustrates the setup for mounting the device vertically on a pipe.
Details on connecting coaxial cables, signal conductors, and screens to terminals.
Instructions for fitting the SENSORPROM unit and mounting the signal converter.
