Set time
Possible only for device type 1323.02! (Example 21:45)
LC display
1.
Turn on the ignition. The last selected option will ap-
pear in the second line of the display: time or daily kilo-
metre reading.
2.
Switch over to time display, if necessary by briefly
pressing the setting knob.
3.
When time is shown, press the setting knob for more
than two seconds: the seconds digits are blinking.
4.
Set current hour by pressing and holding the setting
knob, until desired numeral appears.
5.
Touch again: the minute digits are blinking.
6.
Set current minute by pressing and holding the setting
knob, until desired numeral appears.
7.
The set time is taken in by briefly pressing the setting
knob.
Note: If the display is in time setting mode and if the setting
knob is not pressed for as long as one minute, the setting
procedure is automatically interrupted.
© Copyright Siemens AG 11
To Next Page
Loading...
