To Next PageTo Next Page
Need help?Do you have a question about the Siemens SITRANS MAG 5100W and is the answer not in the manual?
General| Measuring Principle | Electromagnetic |
|---|---|
| Process Pressure | Up to 40 bar (580 psi) |
| Liner Material | PTFE |
| Electrode Material | Stainless steel, Hastelloy C |
| Pressure Rating | Up to PN 40 |
| Protection Class | IP67 |
| Communication | HART, PROFIBUS PA |
| Medium Temperature | See Process Temperature |
| Ambient Temperature | -10 to +60°C |
| Output Signal | 4-20 mA |
| Power Supply | 24 V DC |
| Material | Carbon Steel |
| Nominal Diameter Range | DN 25 to DN 1200 |
Important points to read and understand before installing the equipment.
Requirements for straight pipe sections before and after the meter.
Warning and illustration against creating vacuum in the pipe.
Procedures for equalizing electrical potential for safety and performance.
Details electrical connections for sensor, electrode, and coil cables.
Details available power supply voltage ranges.
Details on setting up the 0/4-20mA current output.
Step-by-step guides for setting range and output functions.
Procedure to disable panel key-press zero resetting for trading.
