Need help?Do you have a question about the Siemens SITRANS F M MAG 5100 W and is the answer not in the manual?
General| Type | Electromagnetic Flowmeter |
|---|---|
| Communication Protocols | HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Measurement Principle | Electromagnetic induction |
| Accuracy | ±0.2% of measured value |
| Output Signal | 4 to 20 mA |
| Power Supply | 24 V DC |
| Lining Material | PTFE |
| Electrode Material | Stainless steel, Hastelloy |
| Protection Class | IP67 |
| Material | Stainless steel |
Covers general requirements and instrument safety standards compliance.
Details requirements for using equipment in hazardous areas.
States where certificates and hazardous area approvals can be found.
Outlines safety measures during installation to prevent hazards.
Provides guidance on selecting an optimal installation site for the flowmeter.
Recommends sensor orientations for optimal performance and minimal issues.
Details how to properly mount the sensor in pipelines and avoid vibrations.
Explains the need for and method of potential equalization for accurate results.
Specifies checks and warnings before making electrical connections.
Details steps for remote sensor installation and cable connections.
Outlines tests for checking sensor resistance and insulation.
Addresses causes and solutions for fluctuating displayed process values.
Provides general technical specifications for the MAG 5100 W sensor.
To Next Page