Siemens SITRANS MAG 5100W - Remote Installation - Integrated Type; Step 1: Prepare Terminal Box; Step 2: Connect Coil and Electrode Cables; Step 3: Connect Earth and Signal Wires

7
www.siemens.com/flowdocumentation
Order no.: A5E02451851-01
Remote installation
CH
Remote installation
CH
CH
Step 4
Mount the connection plate in the terminal box. The SENSORPROM unit
connections will be established automatically when the connection plate is
mounted in the terminal box..
CH
Step 5
Fit the supply and output cables respectively and tighten the cable glands to
obtain optimum sealing.
CH
Step 1
Remove and discard the terminal box lid of the sensor. Fit the cable glands for the
supply and output cables.
Step 2
Remove the two black plug assemblies for coil and electrode in the terminal box an
connect them to their corresponding terminal numbers on the connection board.
CH
Step 3
Connect earth wire on connection board to bottom of connection box.
Connect the 2 pin connector and 3 pin connector as shown.