9
Connections
Electrical connections
Connect the washing machine only to
alternating current via a properly installed
earthed socket.
The mains voltage must correspond to the
voltage specification on the washing
machine (nameplate).
Connection specifications as well as the
required fuses are stipulated on the
appliance nameplate.
Ensure that:
•
the mains plug and socket are compatible,
• the cable cross-section is adequate,
• the earthing system has been installed
correctly.
Do not use multiple plugs/sockets or
extension cables.
In the event that an earth-leakage circuit
breaker is to be used, only use types
marked with the following symbol:
.
Only this symbol can guarantee
compliance with all current regulations.
Do not insert/pull out the mains plug with
wet hands.
Do not pull out the mains plug by tugging
the cable.
Installation
Safety Instructions
Risk of Injury!
The washing machine is very heavy. Take
care when lifting it.
Frozen hoses may tear or burst. Do not
install the washing machine in an area
where there is a risk of freezing or
outdoors.
Do not lift the washing machine by any
projecting parts (e.g., lid handle). The
washing machine may be damaged.
In addition to the safety information listed here,
the local water and electricity supplier may
have special requirements.
If in doubt, have the appliance connected by
a specialist.
Installation surface
Stability is important so that the washing
machine does not ”wander“ during the spin
cycles. Surfaces used for installation must
be solid and even. Soft floor coverings, e.g.
carpets or floor coverings with a foam
backing are not suitable.
Adjustable feet:
(depending upon model)
Some appliances have two adjustable feet
available at the front with can be used to
correct for surface unevenness. Level and
stabilise the machine in the following
manner:
- Tip the washing machine gently
backwards.
- Depending upon the condition of the floor,
either turn out or screw in the foot or feet
(Figure 8)
.
- Check the stability of the washing machine.
Figure 8
Changing the mains lead
For reasons of safety, the mains lead is only
to be replaced by Customer Service which
is authorised to do so.
To Next Page
Loading...
