Faults and what to do about them en
31
3 Faults and what to do
about them
Faults and what to do about them
Emergency release, e.g. if a
power failure occurs
The programme continues running
when the power supply is restored. If
the laundry is still to be removed, the
door can be opened as described
below:
:Warning
Risk of scalding!
When washing at high temperatures,
you may be scalded if you touch hot
washing water or the laundry.
If required, leave to cool down.
:Warning
Risk of injury!
If you reach into the rotating drum, you
may injure your hands.
Do not reach into the rotating drum.
Wait until the drum stops rotating.
Caution!
Water damage
Leaking water may cause damage.
Do not open the door if you can still see
water through the glass.
1. Turn the programme selector to
$ Off. Pull out the mains plug.
2. Drain the detergent solution.
3. Pull down emergency release with
a tool and release.
Door can then be opened.
Information on the display panel
Display Cause/Remedy
A:01 Close the door immediately because of the rising water level. If an interruption
occurs, A:01 and OPEN are displayed alternately.
A:02 The door is locked for safety reasons (water level and/or temperature too high).
■ Washing programme: In pause mode, A:02 and PAUS are displayed
alternately. If you need to open the door, wait for the temperature to drop or
drain the water (e.g. select q Rinse/Spin 0 or Empty p).
■ Drying programme: If you have to open the door, wait until the tempera-
ture has dropped slightly or set the drying programme to 15 min to cool
down the laundry.
If A:02 is frequently displayed at the end of the drying programme:
■ Clean the air filter ~ Page 30
■ Run the Fluff Clean 7 cold programme without laundry.
A:03 Door cannot be locked/unlocked due to high temperature of door lock. Keep
the washer dryer switched on for about 1 min. Or switch off then switch on to
any programme. The washer dryer can then be locked/unlocked again.
To Next Page
Loading...
Need help?
General
