en Faults and what to do about them
32
Faults and what to do about
them
hot The door cannot be opened after the drying programme due to the high temper-
ature. The cooling down process will continue until the display disappears and
the door can be opened.
| ■ Flashes (no water supply): Tap turned on? Inlet filter blocked? Clean the
inlet filter ~ Page 30
Supply hose kinked or blocked?
■ Lights up (low water pressure): For information only. This will not extend
the programme duration.
E:18 Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
ªªª ■ Hold down button Ù (Drying) for 3 s to clear this display.
■ Clean the air inlet filter ~ Page 30
■ Run the Fluff Clean 7 programme without laundry.
LO kg, HI kg Laundry amount information. On when drying phase finished.
LO kg: Signals a small load for drying, HI kg: Signals a very high load for drying.
Other displays Turn the programme selector to $ Off. The appliance is switched off. Wait 5 s
and switch on again. If the display is indicated again, call customer service.
Display Cause/Remedy
Faults Cause/Remedy
Water is running out. ■ Correctly attach/replace drainage hose.
■ Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■ ! (Start/Reload) not selected?
■ Tap not open?
■ Filter blocked? Clean the filter ~ Page 30
■ Supply hose kinked or jammed?
The washer dryer door
cannot be opened.
■ Safety function active. Programme stopped?
■ – – – (Rinse stop = without final drain/spin cycle) selected?
■ Can be opened with emergency release only? ~ Page 31
■ Childproof lock active? Deactivate.
Programme does not
start.
■ ! (Start/Reload) or 0 (Finish in) selected?
■ Door closed?
Detergent solution is not
drained.
■ – – – (Rinse stop = without final drain/spin cycle) selected?
■ Clean the drain pump ~ Page 29
■ Clean outlet pipe and/or drainage hose.
Water not visible in the
drum.
Not a fault – water below the visible area.
To Next Page
Loading...
Need help?
General
