Installation and connection en
41
2. Carefully turn on the tap and check
that the connection points are not
leaking.
Note: The screw connection is under
water pipe pressure.
Water drainage
Notes
■ Do not kink or overextend the water
drainage hose.
■ Height difference between the
placement area and drainage point:
Minimum 60 cm –
maximum 100 cm.
Drainage into a wash basin
:Warning
Risk of scalding!
When washing at high temperatures,
you may be scalded if you touch the hot
washing water (e.g. if draining hot
washing water into a washbasin).
Do not touch the hot washing water.
Caution!
Water damage
If the attached drainage hose slips out
of the washbasin due to high water
pressure when draining the appliance,
leaking water may cause damage.
Secure the drainage hose to prevent
it from slipping out of the washbasin.
Caution!
Damage to appliance/textiles
If the end of the drainage hose is
immersed in the drained water, water
may be drawn back into the appliance
and damage the washer dryer and/or
textiles.
Ensure that:
■ the sealing plug does not block the
outflow of the washbasin.
■ the water drains quickly enough.
■ the end of the drainage hose is not
immersed in the drained water.
Installing the drainage hose:
Drainage into a siphon
The connection point must be secured
with a Ø 24–40 mm hose clip
(specialist store).
Connecting
To Next Page
Loading...
Need help?
General
