Siemens WG44B209GB - Detergents and Care; Products; Basic Operation; Switching on the Appliance

en Detergents and care products
32
12 Detergents and care
products
The manufacturer's instructions for
use and dosage can be found on the
packaging.
Notes
¡ When using liquid detergents, only
use liquid detergents that are self-
flowing
¡ Do not mix different liquid deter-
gents
¡ Do not mix detergent and fabric
softener
¡ Do not use products that have ex-
pired or are highly congealed
¡ do not use products containing
solvents, caustic agents or volatile
substances
¡ Use dyes sparingly as salt may
damage stainless steel
¡ Do not use color-bleaching agents
in the appliance
operation
13 Basic operation
operation
13.1 Switching on the appli-
ance
Note:If you switch the appliance on
the first time after you have connec-
ted it to the electrical system, the
switch-on process takes up to one
minute.
Requirement:The appliance has
been correctly installed and connec-
ted.
→"Installation and connection",
Page12
▶ Press .
The switch-on process takes a few
seconds.
Note:The lighting for the drum goes
out automatically.
13.2 Setting a programme
1. Turn the programme selector and
set the required programme.
→"Programmes", Page27
2. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page32
Setting additional programmes
Requirement:HomeConnect is set
up.
→"Setting up HomeConnect",
Page36
1. Set the App programs pro-
gramme.
If Remote Start flashes,
2. Press Remote Start .
The HomeConnect app displays
the programmes that can be selec-
ted.
3. Set a programme in the
HomeConnect app.
4. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page32
5. Start the programme.
→"Starting the programme",
Page34
13.3 Adjusting the pro-
gramme settings
Requirement:A programme has
been set.
→"Setting a programme", Page32
▶ Adjust the programme settings.
→"Buttons", Page24
Observe the information about op-
erating logic →Page18.