Siemens WG44B209GB - Adding Detergent and Care Product; Starting the Programme; Adding Laundry; Cancelling the Pro- Gramme

en operation
34
2. Slide the measuring aid forwards.
3. Fold the measuring aid down and
click it into place.
4. Push in the detergent drawer.
13.8 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→Page32.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page17
3. If required, add the care product.
4. Push in the detergent drawer.
13.9 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page32
▶ Press ⁠ .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press ⁠ .
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page23
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press ⁠ .
13.11 Cancelling the pro-
gramme
1. Press ⁠ .
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→"Programmes", Page27