EasyManuals Logo

Siemens WM..U... User Manual

Siemens WM..U...
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Operating the appliance en
19
Notes
To remove the laundry at the end of
the programme,deactivate the
childlock.
The childlock remains active, even
once the appliance has been
switched off.
If the appliance is switched off while
the programme is running and
childlock is activated, the
programme continues when the
appliance is switched back on.
Adding/removing laundry
After starting the programme, you can
add or remove laundry if necessary.
Touch the I button. The appliance
checks whether reloading is possible.
If the following appears on the Touch-
Display:
The symbol Œ disappears, reloading
is possible.
The symbol Œ lights up, reloading is
not possible.
To continue the programme, touch the
I button. The programme continues
automatically.
Notes
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1. Touch the I button.
2. Select another programme.
3. And touch the I button again. The
new programme starts from the
beginning.
Cancel the programme
For programmes at high temperatures:
1. Touch the I button.
2. To cool down laundry: Select
q Rinse/Spin 0.
3. And touch the I button again.
For programmes at low temperatures:
1. Touch the I button.
2. Select q Rinse/Spin 0.
3. And touch the I button again.
Programme end during rinse
hold
The I button flashes on the Touch-
Display, and the preset spin speed and
remaining programme length are
displayed for the selected programme.
Continue the programme by:
Touch the I button or
Change the spin speed (if
necessary) and then touch the I
button again.
Note: If the water only needs to be
drained, touch the I button approx.
1 minute after the programme starts,
before the spin cycle begins. Then
switch the appliance off. The
programme is interrupted and the
door lock is released. The laundry
can be removed.
Programme end
End lights up on the Touch-Display and
I and Œ diaplays are off.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens WM..U... and is the answer not in the manual?

Siemens WM..U... Specifications

General IconGeneral
BrandSiemens
ModelWM..U...
CategoryWasher
LanguageEnglish

Related product manuals