NLTroubleshooting
Malfunction Cause and Troubleshooting
No water flows into
the device. The
detergent was not
washed in.
Water supply hose is kinked or pinched.
▶ Make sure that the water supply hose is not
kinked or trapped.
Start several times
with centrifugation.
The imbalance control system removes the imbalance
by distributing the laundry several times.
▶ No error - no action required.
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
The program duration
changes during the wash
cycle.
The program sequence is optimized electronically. This
may lead to changes in the program duration.
▶ No error - no action required.
The imbalance control system removes the imbalance
by distributing the laundry several times.
▶ No error - no action required.
Remark:When loading, if possible, place large and
small items of laundry together in the drum. Laundry
of different sizes is distributed better during the spin
cycle.
Foam control system performs an extra rinse in case
of excessive foam formation.
▶ No error - no action required.
The water is not
visible in the drum
bar.
The water is below the visible range.
▶ No error - no action required.
▶ Do not fill the appliance with additional water during
operation.
Drum shakes
program start.
The cause is an internal engine test.
▶ No error - no action required.
In the compartment
there is residual water.
Insert in compartment is clogged.
▶
→
"Cleaning the detergent drawer", page
34
Vibration and movement
of the appliance
during the centrifuge
run.
The appliance is not leveled properly.
▶
→
"Adjusting the device", page 16
Device feet are not fixed.
▶ Secure the device feet.
→
"Adjusting the device", page 16
Transport protection devices have not been removed.
44
To Next Page
Loading...
