Siemens WM14UPH0IN - Detergents and Care; Products; Basic Operation; Switching on the Appliance

Detergents and care products en
31
12 Detergents and care
products
The manufacturer's instructions for
use and dosage can be found on the
packaging.
Notes
¡ When using liquid detergents, only
use liquid detergents that are self-
flowing
¡ Do not mix different liquid deter-
gents
¡ Do not mix detergent and fabric
softener
¡ Do not use products that have ex-
pired or are highly congealed
¡ do not use products containing
solvents, caustic agents or volatile
substances
¡ Use dyes sparingly as salt may
damage stainless steel
¡ Do not use color-bleaching agents
in the appliance
¡ Do not pour vinegar into the dis-
pensers →Page34 of the intelli-
gent dosing system
operation
13 Basic operation
operation
13.1 Switching on the appli-
ance
Requirement:The appliance has
been correctly installed and connec-
ted.
→"Installation and connection",
Page12
▶ Press .
The switch-on process takes a few
seconds.
a An audible function test is carried
out.
13.2 Setting a programme
1. Turn the programme selector and
set the required programme.
→"Programmes", Page26
2. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page31
13.3 Adjusting the pro-
gramme settings
Requirement:A programme has
been set.
→"Setting a programme", Page31
▶ Adjust the programme settings.
→"Buttons", Page23
Observe the information about op-
erating logic →Page18.
Notes
¡ The programme settings are not
saved permanently for the pro-
gramme.
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡ A programme is set.
→"Setting a programme",
Page31
¡ The programme settings have
been adjusted.
→"Adjusting the programme set-
tings", Page31
▶ Press and hold for approx. 3
seconds.
Press to call up the saved pro-
gramme.