Siemens WM14UPH0IN - Filling the Dispensers; Tem

en Intelligent dosing system
34
¡ Pour detergent or fabric softener
into the compartment for manual
dosing.
→"Adding detergent and care
product", Page32
¡ Activate the intelligent dosing sys-
tem once the programme has
ended.
→"Buttons", Page23
→"Buttons", Page23
Requirements
¡ The laundry is prepared.
→"Preparing the laundry", Page30
¡ The laundry is sorted.
¡ The laundry is placed in the appli-
ance.
→"Loading laundry", Page32
¡ The programme is set.
→"Setting a programme", Page31
¡ The intelligent dosing system is ac-
tivated.
→"Buttons", Page23
→"Display", Page21
→"Display", Page21
1. Fill the dispensers.
→"Filling the dispensers",
Page34
To replace the contents of the dis-
penser with another product, clean
the detergent drawer.
→"Cleaning the detergent drawer",
Page40
2. If required, adjust the contents of
the dispenser →Page35.
3. If required, adjust the basic
dosage →Page35.
4. If required, adjust the programme
settings.
→"Adjusting the programme set-
tings", Page31
5. Start the programme.
→"Starting the programme",
Page32
6. Remove the laundry.
→"Unloading the laundry",
Page33
15.2 Filling the dispensers
If you want to use the intelligent dos-
ing system or if the appliance dis-
plays a notification during operation
of the appliance, fill the dispensers.
Note:Fill the dispensers only with
suitable detergent and care products
→Page31.
If you want to add more liquid deter-
gent or fabric softener in the dis-
penser, use the same product.
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→"Cleaning the detergent drawer",
Page40
If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers →Page35.
Requirement:The display shows a
notification to fill the dispenser.
→"Display", Page21
→"Display", Page21
1. Pull out the detergent drawer.
2. Open the dispenser cover.