Siemens WM14UPH0IN - Deactivating Wi-Fi on the Appliance; Resetting the Appliance Network Settings; Remote Start; Data Protection

HomeConnect en
37
16.4 Deactivating Wi-Fi on the
appliance
1. Press and hold for at least
threeseconds.
2. Set the programme to position 4.
a The display shows Con.
3. Press repeatedly until the dis-
play shows oFF.
a Wi-Fi is deactivated.
Note:The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.5 Resetting the appliance
network settings
1. Press and hold for at least
3seconds.
2. Set the programme to position5.
a The display shows rES.
3. Press .
a The display shows Yes.
4. Press .
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
16.6 Remote start
Enable the appliance for remote start
via the HomeConnect app.
Note
Remote start is deactivated for safety
reasons in the following
circumstances:
¡ The appliance door is opened.
¡ is pressed.
¡ is pressed.
¡ The appliance is switched off.
¡ Following a power cut.
Activating remote start
Requirements
¡ The appliance is connected to your
home WiFi network.
¡ The appliance is connected to the
HomeConnect app.
¡ A programme is selected.
¡ The appliance door is closed.
¡ The detergent drawer has been
pushed in.
▶ Press .
a lights up and the appliance is
enabled for remote start via the
HomeConnect app.
Deactivating remote start
▶ Press .
a goes out.
16.7 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the HomeConnect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
This initial registration prepares the
HomeConnect functions for use and
is only required when you want to
use the HomeConnect functions for
the first time.